Recent Posts

Pages: 1 [2] 3 4 ... 10
11
General Discussion / SCJ Oil Cooler Lines
« Last post by Scott on May 24, 2019, 08:59:38 pm »
Need to replace the upper line and reading several posts on how hard they are to come by.  Is there a way that the hose only can be replaced professionally? If not, where can I find a replacement?
Thanks!
12
General Discussion / Carburetor Gaskets to manifold and spacer?
« Last post by Mike_B_SVT on May 24, 2019, 08:48:22 pm »
I know Mansfield has the 2 gaskets (carb to spacer and spacer to manifold).

Are they actually two different gaskets, or are they the same? 

Is there anyplace else I can get them?  Or a particular part number for them?

Do they require any sealer?  I don't think they do, but figured I'd better check.


I'm going to be dealing with a leaky secondary bowl / metering block, and thought it might be a good idea to replace these gaskets as well while I have the carb off.
13
General Discussion / MOVED: Grabber Blue 68.5 CJ
« Last post by sah62 on May 24, 2019, 05:35:57 pm »
14
General Discussion / Re: Stock exhaust question
« Last post by jackmi on May 24, 2019, 12:46:37 pm »
My H-pipe was a bit tweaked as well, but it didn't take much persuasion to get it corrected. 
15
General Discussion / Re: Stock exhaust question
« Last post by corbins on May 24, 2019, 07:57:35 am »
Using the correct components you should not be having a problem ?  Brian
Brian, you are probably correct , but I am forced to use AM Z-bar , and the h-pipe is used. I'll have to do a bit of twisting and compressing of the H-pipe.  At least I know it should fit  :)

Thanks
16
General Discussion / Re: Stock exhaust question
« Last post by 428 CJ hardtops on May 23, 2019, 10:43:47 pm »
I think they are .
17
General Discussion / Re: Stock exhaust question
« Last post by Brian Conway on May 23, 2019, 09:51:47 pm »
No I do not. 
18
General Discussion / Re: Stock exhaust question
« Last post by preaction on May 23, 2019, 09:49:38 pm »
Brian do you know if the Z bars are the same for 68 and 69/70 ?
19
General Discussion / Re: Stock exhaust question
« Last post by Brian Conway on May 23, 2019, 09:05:25 pm »
Using the correct components you should not be having a problem ?  Brian
20
General Discussion / Re: Stock exhaust question
« Last post by corbins on May 23, 2019, 07:34:28 pm »
Thanks guys !!!  looks like I have some massaging to do, she's binding up against the Z-bar.
Pages: 1 [2] 3 4 ... 10